fbpx JOIN LOGIN JOIN

BLIGHT SHROUD TERMINATOR - 3 PACK

PGTM-ST-BlightShroud-abc
$44.99
In stock
1
Product Details

The Blight Shroud Terminators are old and wear the Saturnus-Pattern Armor, but are now corrupted by the lord death and decay. They were designed and sculpted by the free-blade artist, KarnageKing. These are full model kits.



Monkey Resin is a high-quality UV cured resin that will come attached to a support structure from the production process. The parts are however, pre-cleaned and ready for primer once removed. Use only super glue to adhere these parts to your models.



To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports all together.



You can use a very fine-grit sandpaper if needed to smooth any surface or feature further. Always be sure to wear a mask when working around resin dust.




*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.

  • All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
  • Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
  • The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
  • To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
  • Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.
Save this product for later