DeamonSlayer-Spartans are the most ancient among the DeamonSlayer armor. They are piloted by legends of tactical warfare and keepers of ancient lore. On the battlefield, they combine ancient knowledge and strategy to devastate the endless deamon hordes.
The multipart DeamonSlayer-Spartan is made to a 25-micron standard on a high-quality resin printer. Fully assembled it stands 11cm tall. It can be assembled in a wide range of poses with weapon and customization options.
The Spartan Kit comes with the following, including a newly redesigned chest, bracers, and two head bits!
The kit contains over 70 parts (base not included) including a Hurricane Roto Cannon, Inferno Flamer, and Psycho Cannon.
The Five other shooting weapons, the back-mounted weapon adapter, the wrist bolters, and flamers, plus an extra of each short sword and ax (so you can dual wield) and are in the optional weapons pack available separately here. They are all pictured above and are not included with this base kit.
Fully assembled it stands 11cm tall about 4"- same as a Dreadknight or Telemon.
Perfect as a centerpiece for your tabletop army, as a cool display piece on your desk, or even as parts for use in your conversions!
It's a very cool kit that can be used for a number of things from the Invictor Warsuit to any Contemptor class, and more.
This model is about 150ml of resin and takes roughly 6 Anycubic Photon sized printing plates about 24 total hours to produce
View the instructions for how to assemble your DeamonSlayer-Spartan! in the picture gallery above
Miniatures Sales & Marketing Contracted Though Spikey Bits, and Fulfilled By Slicer LLC.
It will be printed in our new Void Resin that makes 3d prints feel and act more like plastic, plus the strength benefits are amazing. Watch us disrespect a model printed with Void Resin below:
All products are printed to a 25-micron standard using high-quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.