Murmillo Upgrade Conversion Bits For Space Marines Primaris Gladiator Tank

If you want to turn your Impulsor into a Gladiator Lancer, Reaper, or Valiant, this new Murmillo tank conversion bits kit makes it easy and affordable to upgrade!

A multipart kit of the Murmillo Tank Upgrade For Hover Tank will be made for you on a high-quality resin printer. It makes a great Gladiator tank upgrade kit for the Space Marines Impulsor, and the back hardtop fits perfectly over top of the Impulsor Tank by Games Workshop with no cutting required.

This Kit Contains:

• back bulkhead (back, door, back vents)
• top turret mounting ring and roof
• turret (bottom, top, back, two antennas, antenna holder)
• all three turret weapon variants (lastalon, gatling, laser+visor bits) to make a Lacer Laser Destroyer, Twin-Linked Las-Talon, or Twin-Linked Heavy Onslaught Gatling Cannons
• 2 side weapon variants (quad bolter and melta)
• hatch and hatch door (the hatch is possible to break in two parts for the open top.
• turret grenade launchers
• Turret Weapons come pre-drilled for magnets so you can swap them out just glue magnets inside the turret before you close it up!

The back door is the same as Bitshapers Repulsor series and fits perfectly with any other Repulsor backdoors.

This product is officially licensed by Bitshapers. If you are after just the .STL files, they are available on Bitshapers Cults Page Here

Instructions for how to assemble your kit are above in the Image Gallery

Miniatures Sales & Marketing Contracted Though Spikey Bits, and Fulfilled By Slicer LLC.

*NOTE: Neither Slicer LLC, or Spikey Bits are affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.

• All products are printed to a 25-micron standard using high-quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
• Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
• The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
• To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
• Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.