WINGED SWORD : FULL RHINOBACK IMPULSOR KIT - Pop Goes the Monkey
Our Rhinoback Impulsor conversion bits kit is a variant of the standard Primaris Impulsor design that incorporates an enclosed crew compartment to better protect your troops traversing across the battlefield.
This conversion kit is meant to fit the Primaris Impulsor model kit (Not the Repulsor kit). We kept the standard “Top-Hatch” fitting of our Rhino Chassis parts so, this kit will allow you to incorporate many of our other conversation parts like missile launchers and turret weapons.
The front plate replaces the associated part of the Impulsor kit, but the rest of the parts like the crew compartment and vehicle insignias are simply added onto your model. The best part is that our branded tailgate slots into a working hinge on the back section of the crew compartment. It can open and once it’s closed, it snaps into place.
Browse the full lineup of upgrade bits for your miniatures on the Pop Goes the Monkey webstore.
All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
To remove the bits from their supports:submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.