Sci-Fi Ruler Miniature 3dArtGuy

SKU 3dArtGuy-RU
In stock
Product Details


The Big guy is back to take over the universe for humanity and crusade across the stars once again!

...to counter such horrors, we have a mythical figure of incalculable might. His identity is shrouded in mystery but this figure has always been destined to rule. All demons fear the fire and death that the Ruler will bring to them.

This may be the Ruler miniature we've always wanted! Do not miss 3DArtGuy's awesome design! A multipart kit of his Patreon Exclusive- will be made for you on a high-quality resin printer.

  • This model is approximately 63.5 mm (2-1/2") tall to the top of his helmet (a little taller than Bobby G- who is about 55mm).
  • The Ruler is a 12 piece multi-part kit, including three different head options, two helmets, and one with luxurious locks.
  • His arms are separate at the shoulders, as well as his head for maximum hobbying.

It's printed to a 25-micron standard in our new Void Resin that makes 3d prints feel and act more like plastic, plus the strength benefits are amazing.

Watch us disrespect a model printed with Void Resin below:

The Ruler is a warrior of incomparable zeal and fury, hunting down heretics and making them regret all their life choices. This obviously makes a great Emperor of Mankind miniature and towers over Prmarchs and Space Marines alike in the Horus Heresy! Plus he would make a great alternative Roboute Guillimane miniature in Warhammer 40k as well.

  • We are an official licensee of 3DArtGuy. Miniatures Sales & Marketing Contracted Though Spikey Bits and Fulfilled By Slicer LLC.

Support 3DArtGuy on Patreon if you are after just the .STL files!

  • All products are printed to a 25-micron standard using high-quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
  • Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
  • The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
  • To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
  • Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.
Save this product for later

Comments are closed.

Go to Top