fbpx JOIN LOGIN JOIN

HOBBY: Converting a Canoptek Necron Scorpion

canoptek scopion

If you love killer robots then you may not want to miss this awesome conversion idea for turning a Necron Wraith into a Canoptek Scorpion that you can use for an alternate model or even a Spyder.

A few years ago when the plastic Wraith models first came out I tinkered around with the parts for a little while, until it just hit me to just turn them upside down and create something new i liked to call the Canoptek Scorpion!I hope you like the result, I call it the Canoptek Scorpion and I use them for my Spyder models.  

You can, of course, use them for whatever really, however, their “footprint” is just a little too big to mount to a 40mm base for using as Wraiths.

Parts List 
  • Dark Eldar Talos Tail
  • One Necron Canoptek Wraith Sprue
  • Optional Necron Spyder Head
The Conversion

You can pretty much see what I did with this model in the picture above.  I basically just reversed the curve of the Wraith model and made their “belly” the top of the model.I also made some baby scorpion models to use as scarabs out of some spare Necron parts I had lying around to go with whole Spyder counts-as theme I have in my army as well.

First off you need to cut down the two armor plates that normally go on the top of the model, as shown.

They need these cuts to be able to reverse their angle and go from curving around the back to curving around the front of the model. 

Then just start building the wraith as normal attaching the sections of its torso together. As you can what is normally the “belly” of the wraith is now the “top”.

I also started adding sets of legs at this point so the assembly would hold itself together as it got built up, and hold the weight of the tail that would go on top when the time came.

Next, you can add the armor plates that normally go on the back of the model to what is now the top of the model. If you cut them down carefully, they should fit right over what is now the top of the model as they are mirror images meant to go on the old top of the model (which is now the bottom).

Just keep building up the back of the model, adding sections and armor plates. Here I also added a spare Spyder head I had to the front of the model to check the proportions.

Next just clip the little nub off the Talos tail and glue it flush to the socket where the Wraith tail would normally go.  By now the glue from the legs should be dry and the model should be able to hold the weight of the tail.

Then just plug and play the rest of the parts into the correct sockets as pictured above. Don’t forget to add the middle set of legs!

That’s pretty much it, you can play around with the angle of everything to simulate motion and such, but the basics of the assembly are done.  I made a few with their claws opened wide, and some more in a guarded position like above.

Honestly, it seemed to take way more time just trimming and deflashing all the bits to make it, than actually assembling it!

Click play below to check out the entire How-To video for making this Canoptek Scorpion!

About the Author: Rob Baer

Virginia Restless, Miniature Painter & Cat Dad. I blame LEGOs. There was something about those little-colored blocks that started it all... Twitter @catdaddymbg